Prescott RV Garages
Detached RV garage with a tall sectional door beside a stucco ranch home, with granite boulders and junipers

Prescott · Prescott Valley · Chino Valley · Dewey-Humboldt

RV Garages in Prescott, AZ

We plan and build RV garages, RV carports and RV storage buildings for homes across the Prescott area. Each one is sized to the rig you own now and the one you might buy next, engineered for local snow and wind, and taken through the permit for your town. It starts with a free on-site estimate.

Updated November 2026

Free on-site estimateWritten scope and price
One point of contactFrom site plan to final inspection
Four towns servedPlus nearby county land
Fast replySame or next business day

Why an RV garage here

Sun, snow and HOA letters are hard on an RV parked outside

At 5,000 feet and up, the Arizona sun works on an RV all year. Roof membranes chalk and crack, decals fade, and tires dry-rot while the rig sits in the side yard. Then winter brings snow loads and freeze-thaw cycles, and the monsoon brings wind and hail from July into September. A covered or fully enclosed RV building keeps all of that off the coach, and it often pays for itself in roofs and tires you don't have to replace.

There's a second reason too. Many neighborhoods in Prescott and Prescott Valley have rules about parking an RV in view of the street, and storage lots fill up and raise their rates. An RV garage on your own lot keeps the rig close, plugged in and ready to load for the next trip to the Mogollon Rim or the river.

Every building we plan starts with three numbers: how tall the rig is with its air conditioner and antenna, how long it is with the hitch, and how you'll back it in. Get those right and the building works for decades. Get them wrong and the door is six inches short.

Sizing

How big should an RV garage be?

Size the building to the rig, then add room to walk around it and open the slides. These are the starting points we use before we measure your RV.

Your rigTypical lengthBay we start withDoor
Truck camper or van20 to 24 ft14 x 30 ft12 ft wide x 12 ft tall
Travel trailer22 to 34 ft with hitch14 x 40 ft12 x 12 or 12 x 14 ft
Class C motorhome24 to 33 ft16 x 40 ft12 x 14 ft
Fifth wheel30 to 42 ft with pin box16 x 50 ft14 x 14 ft
Class A diesel pusher36 to 45 ft16 x 55 or 18 x 60 ft14 x 14 ft

Lengths are typical ranges, not specs for any one model. Measure your rig from the hitch or front bumper to the ladder or bike rack, and from the ground to the top of the roof air conditioner. Angi puts the average RV garage at about 14 by 50 feet, or roughly 700 square feet (Angi, 2026).

How it works

From your driveway to a finished building

  1. Free estimate

    We walk the lot with you, measure the rig, check the turn-in and the slope, and note where power and water could come from.

  2. Written scope

    You get one price for the building, the slab, the door and any power, with the snow and wind loads it is designed for.

  3. Permit and plans

    Engineered drawings go to your town or to Yavapai County, along with the site plan the planners ask for.

  4. Build and final

    Site work, slab, building and door, then the final inspection. You get the signed-off permit for your records.

Built for this climate

Snow load, wind and monsoon water

An RV garage here is a tall building with a big door, and both of those matter to the engineer. The City of Prescott sets a minimum roof snow load of 30 pounds per square foot, and its 2024 code design criteria ask for a site-specific snow report from the ASCE Hazard Tool and a 105 mph wind design. Higher lots toward Groom Creek and the Bradshaws can call for more.

Metal buildings get their own review in Prescott, under the city's metal building technical guide. That's why we price stamped, engineered buildings, not carport kits rated for somewhere else. The big door also needs a wind-rated frame around it, because a 14-foot opening catches a lot of air.

Water is the other local issue. Monsoon storms dump an inch in an hour, and decomposed granite washes fast. We set the slab above grade, slope the apron away and plan where the roof water goes, so it doesn't run under the door or across a neighbor's lot.

Empty RV garage interior with white liner panels, LED lights, sealed concrete floor and an RV power pedestal
Tall insulated beige sectional garage door with a row of windows in a metal building with a stone wainscot

What's inside

The details that make an RV garage work

  • The door. A 12- or 14-foot sectional or roll-up door, insulated if you'll work inside in winter. Angi puts RV doors at $1,300 to $7,000.
  • The slab. Thick enough for a loaded motorhome, with a long, gentle apron so the rear doesn't drag on the way in.
  • Power. A 30- or 50-amp RV outlet to keep batteries charged and the fridge cold before a trip, plus shop lights and outlets.
  • Water and dump. A frost-proof hose bib for filling tanks. A dump station needs a sewer or septic tie-in and its own approval.
  • Room to work. Four extra feet down one side lets you open slides, wash the coach or roll a tool cart. A lean-to on the side holds the boat or the UTV.
  • Insulation. A liner and insulation keep condensation from dripping on the roof of the RV in winter, which matters more than most people expect.

Cost

What an RV garage costs

Angi's 2026 data puts the national average at about $90,000, with most projects between $36,000 and $140,000, or $40 to $140 per square foot. An open RV cover costs far less. A framed, stuccoed garage that matches the house sits at the top of the range. The slab, the door, power and site work move the number most.

The RV garage cost guide breaks those numbers down by type and size, has a quick budget tool, and explains what a Prescott-area permit adds.

Before you hire anyone

Check the license

In Arizona, work that needs a building permit, or that costs $1,000 or more in labor and materials, has to be done by a contractor licensed with the Registrar of Contractors. You can look up any contractor on the Arizona ROC website, including complaints. Ask for the license number in the written estimate and check that the license class covers the work.

If you're in an HOA, ask the board for the architectural rules before you design anything. Height limits and color rules are common.

RV garage questions

How tall does an RV garage door need to be?
For most fifth wheels and Class A motorhomes, a 14-foot door. Arizona's legal vehicle height is 13 feet 6 inches, so 14 feet clears any road-legal rig. Smaller travel trailers and Class C coaches often fit a 12-foot door, but measure to the top of the roof air conditioner first.
Do I need a permit for an RV garage in Prescott?
Yes. An enclosed RV garage or a large RV cover needs a building permit from the City of Prescott, Prescott Valley, Chino Valley, Dewey-Humboldt or Yavapai County, depending on where you live. Expect engineered plans and a site plan. We handle the permit as part of the job.
Is a metal RV garage or a framed one better?
A steel building usually costs less and goes up faster, and it spans the width without posts. A framed garage costs more but can match the house exactly, which some HOAs require. Both work in our snow and wind when they're engineered for the site.
Can I build an RV garage before I build my house?
Usually not by itself. Prescott Valley and Dewey-Humboldt allow an accessory building first only when the house permit has been issued and construction starts within six months. Check your town's rule before you plan the order of work.

Free on-site estimate

Tell us what you drive. We'll size the building around it.

Send the town, the rig and roughly where it should go. We look at the lot, the turn-in and the slope, then send a written scope and price for the building, the slab and the door.

  • Door height and bay length checked against your RV, with room for the next one
  • Permit path for your town or Yavapai County, plus HOA rules if you have them
  • One written price that names what's in it and what isn't

Prefer to talk? (928) 340-0062

Call now Free estimate